Got a split keyboard (ergodox ez) just to notice that all the special keys are very tough to reach and there are no F-keys. All in all not such a great experience. The split part is good though if you type a loooot anf if you have wrist rests.
Got a split keyboard (ergodox ez) just to notice that all the special keys are very tough to reach and there are no F-keys. All in all not such a great experience. The split part is good though if you type a loooot anf if you have wrist rests.
I’m not sure you understand. There is a mute functionality in Meet and there is one in iOS. This is so that you can have different apps with different states of mute. The OS level control is there so you can mute the mic for all apps at the same time.
Look at the post behind the link. There is a dark mode version.
https://lemmy.world/post/9437525
My version of this with a bit more detail
Did you measure that? Would be great if it was only fractions of a mm.
Would a larger inner diameter not cause the transmission of movement to be less direct due to bending and coiling inside the tube? This is probably mostly an issue in bowden systems
Uh, I must admit I don’t know about that bro method.
There are some serious differences between a badly made loaf and a well done one though. You never stop learning. But yeah, it’s easy to get something passable.
Yeah, very nice. It will be tough to bootstrap since you need a critical mass of people who ideally live close together so that it’s cheap and quick enough to deliver the items in question.
I’ll give it a try. Nothing to loose.
What about some rollo blinds? We have them shut during daytime in summer in the rooms we don’t use all the time. They also help sleep in the dark if that’s your thing. The drawback is that they often create a weak spot wrt. Insulation.
Then just keep it and stop buying keyboards for no reason.
Sorry, I completely didn’t read all of your comment. You’re right about resistance but then again the filament won’t need to touch the enclosing coil at a large surface. In the usual bowden tubes, you have a lot of contact surface between tube and filament but this would not need to be the case in the drying coil. In the end it would all depend on the application. I’m not interested in very high speed printing (yet) because my machines are all pretty slow :).
You “just” need a longer distance inside the drying chamber. This could be achieved by coiling up the space where the filament travels through and guide hot and dry air through that space, ideally from the outlet towards the inlet. That air could maybe be pulled from the hotend cooler.
Argh finally someone tries the obvious solution. I was already considering it but was demotivated since it seemed so obvious and nobody seemed to have done it before.
This device could also probably be printed in PLA. I can’t wait until I get my lab power supply so I can give this a try with a wire coil heater.
Edit: you could even mount some PTFE tubing mounted below a heated bed and pass air through it. That way you could potentially get away without a heating element and re-use some power usually lost.
Not only this. It’s also old news.
Full agree!! I use the dev version too!
The 1.0 release is around the corner. It’s only a matter of a few weeks. It has the toponaming problem fixed and a built in assembly toolbox!
I’m interested to hear how it turns out!
Thanks a lot for having taken time to respond so thoroughly. I must say I haven’t thought about things from this angle.
The part about the book and the mediocre comedian definitely rings a bell. Getting stuck in stupid local extrema (like in optimization) more often than necessary is definitely a thing with me.
Rocket.chat could be an option