• 1 Post
  • 35 Comments
Joined 4 days ago
cake
Cake day: June 5th, 2025

help-circle
  • This is a resolution issue, so think about X & Y settings rather than Z settings like layer height. You need to reduce the line width and/or use a smaller nozzle like 0.2mm. You might also have a bit too much squish on your first layer which you could measure by printing a line and measuring it with calipers and comparing the slicer value to the actual value to see if there’s any difference.

    I’m not familiar with PrusaSlicer but Bambu Studio has a wall generating setting called “Arachne” which does a better job of generating the small features/walls you need for text even with a 0.4mm nozzle. You might see if there’s a comparable setting for Prusa.















  • I think the Define 5 is a good option as well. I bought the 6 in 2018 because it was new, was white, and only like $99 at the time and it’s served me well. Every couple of years I’d buy some more drive trays as my pool filled up and I needed more space.

    I just rebuilt my whole system a couple of months ago but kept the case because it works so well and there isn’t much on the market like it without getting into fullsize cases. It’s nearly silent even with 5 fans and 9 HDDs inside. It sits about 2 feet from me on my desk and I only hear a tiny hum from the fans.


  • PC Part Picker has filters that will let you set all your requirements and show you what’s available. Since you want ECC and low cost, you might be better off finding options on PCPartPicker and then looking for those items used on ebay.

    If you don’t have a case already, you might check out Fractal Design. They have several cases for lots of 3.5" drives. I have a Define 6 and it holds like 12 3.5" and 4 2.5" in a midtower format and it’s constructed really well. You will need to buy additional drive trays though as they only come with 4 I think.